The instructions for a Floor are the same as for a Tom.
Reset a Tom / Floor:
- Press the button for 10 seconds, the LED flashes 10 times.
- If all went well, the button will light green for 5 seconds.
- Now try to register the Tom with the Adam.
Can't reset? Maybe your Tom / Floor still has an old firmware. Resetting this is very precise:
- Restart Tom by taking the power off for 10 seconds.
- Tom / Floor can start calibrating, if the pusher extends you hold it back (tip: put a screwdriver through the holes in the ring).
- Wait until the Tom is 'quiet' again.
- Press the button.
- Release shortly after the LED flashes for the 3rd time.
- Press the button again within 1 second.
- Release shortly after the LED flashes for the 3rd time.
- Press the button again within 1 second.
- Release it shortly after the LED flashes for the 10 times.
- Wait 10 seconds and restart the Tom.
- Now try to register the Tom with the Adam.