In the measurements you see the measured and set temperature per zone. Sometimes it can happen that there are gaps in it. Possible causes are:
The batteries of one of the appliances in that zone are low.
If the batteries are almost empty, the device may switch off, switch on and switch off again.
- Check at Menu > Setup > Appliances whether there are appliances with a low battery.
Too many battery powered devices
If there are too many appliances on batteries, the network quality may be too poor. As a result, sometimes one appliance has contact and then the other appliance has contact. The recommended ratio is no more than 5 battery powered appliances per USB/wall powered device.
- Go to Menu > Setup > Devices and choose a battery powered appliance.
- Click Delete > Remove from Network.
- Remove the batteries from the device and insert a micro USB cable.
- Under Appliances, click the circle with a + at the bottom right to add a new appliances. Click the Join button on the apliance to connect it to the Adam HA.
