Boiler and heating
Adam can handle most modern boilers, but not all. Adam communicates with the heating system via the OpenTherm protocol. This means that both the thermostat ...
Thu, 18 Feb, 2021 at 8:42 AM
Nefit boilers Nefit boilers have had different protocols over time to be able to talk to thermostats: - iRT - EMS - OpenTherm Check here which proto...
Tue, 20 Dec, 2022 at 10:17 AM
Adam can, if the boiler supports this, set a number of temperature settings on the boiler: The maximum flow temperature The maximum DHW temperature The ...
Thu, 18 Feb, 2021 at 8:42 AM
Check whether the boiler is plugged in. Check whether the central heating wires are properly connected to the Adam. Always disconnect the power from the boi...
Thu, 18 Feb, 2021 at 8:37 AM
Open connect.plugwise.net in the browser, log in with the ID and make sure your smartphone, tablet or computer is connected to the same network you connecte...
Thu, 18 Feb, 2021 at 8:35 AM
It;s possible! Remove the plug of the boiler and the Adam from the socket. Connect Adam to the other boiler. To do this, follow step 2 in the manual. As soo...
Thu, 18 Feb, 2021 at 8:34 AM
Sometimes it happens that with a certain type, often older, on/off boiler (or pump / valve / gas block) the boiler always remains on. The Adam and Anna ...
Wed, 21 Dec, 2022 at 8:55 AM
What is readjustment or post regulation? Traditionally, you always connect a thermostat to the heat source, such as a central heating boiler or heat pump. ...
Mon, 16 Jan, 2023 at 8:40 AM
Central heating boilers often have a tap water comfort setting (DHW) that is set to on. With this, your boiler keeps your tap water warm so that you quickly...
Tue, 20 Dec, 2022 at 10:13 AM
Some ATAG boilers (including the Q-series) have an ATAG bus thermostat input. The installation manual states that you can also connect an OpenTherm thermost...
Tue, 20 Dec, 2022 at 10:14 AM