Heating
You can already use partial zone control if you have an Adam HA with 1 Lisa, 1 Tom and an OpenTherm thermostats. There is a good chance that your current th...
Fri, 12 Mar, 2021 at 4:13 PM
There are several possible reasons why Adam will not heat: Adam is not properly connected to the boiler. Check the wires. Also check whether the correc...
Fri, 19 Nov, 2021 at 4:55 PM
Flame visible The flame in Adam's screen is always shown when the flame in the cauldron is on. This applies in the following situations: There is hea...
Fri, 26 Mar, 2021 at 4:35 PM
There are several possible reasons why a set temperature is not reached: The zone will get warmer and will eventually reach the set temperature. For ex...
Wed, 17 Feb, 2021 at 3:56 PM
There are several possible causes for a zone to become too hot: If the Plugwise control has just been switched on, it still has to get to know the hous...
Wed, 17 Feb, 2021 at 3:55 PM
If Adam is connected to an OpenTherm thermostat, the thermostat controls when heating takes place. If you have switched on the Plugwise control, the thermos...
Wed, 17 Feb, 2021 at 2:35 PM
Do you set a schedule on the Adam? And have you also set a schedule via the thermostat? Both the thermostat and the gateway follow their own schedule. M...
Wed, 17 Feb, 2021 at 3:54 PM
Do you have a schedule on for a zone and is preheating on? Then Adam is preheating for a zone that is scheduled to be warm soon. Adam will preheat up to 4 h...
Wed, 17 Feb, 2021 at 3:23 PM
The tap water comfort setting is on on the boiler. Then the boiler keeps the water warm to be able to supply hot water at any time. To save money and energy...
Wed, 17 Feb, 2021 at 2:51 PM
Does the measured temperature in a zone with a Lisa look erratic as in the graph below? Then the Lisa is in router mode while it is powered by batter...
Wed, 17 Feb, 2021 at 2:32 PM